SmartPDCode/truing_control/STS/HARDWARE/Fan/Fan.c

/*********************************************************************************************************
* Module   : Fans.c
* Abstract : Fans modules  is used to cool down the device!
* Version  : 1.0.0
* Author   : Leopul(COPYRIGHT 2025 - 2027 Leopul. All rights reserved.)
* Complete : 2025-02-16
* Content  : None
* Note     : None
*********************************************************************************************************/
#include "Fan.h"
#include "gd32f30x_libopt.h"
#include "main.h"


void fans_init(void)
{
	rcu_periph_clock_enable(RCU_GPIOC);  
	gpio_init(GPIOC,GPIO_MODE_OUT_PP,GPIO_OSPEED_50MHZ,GPIO_PIN_9);
  gpio_bit_reset(GPIOC, GPIO_PIN_9);      
	
	sts_data_t *data = get_sts();
	data->fans = fans_on_off;
}


void fans_on_off(unsigned char status)
{
	sts_data_t *data = get_sts();
	if(status == FANS_OFF)
	{
		gpio_bit_reset(GPIOC, GPIO_PIN_9); 
		data->m_data.fans_status = FANS_OFF;
	}else if(status == FANS_ON)
	{
		gpio_bit_set(GPIOC, GPIO_PIN_9); 
		data->m_data.fans_status = FANS_ON;
	}else{
	
	}
}