SmartPDCode/control/STS/HARDWARE/Fan/Fan.c

/*********************************************************************************************************
* Module   : Fans.c
* Abstract : Fans modules  is used to cool down the device!
* Version  : 1.0.0
* Author   : Leopul(COPYRIGHT 2025 - 2027 Leopul. All rights reserved.)
* Complete : 2025-02-16
* Content  : None
* Note     : None
*********************************************************************************************************/
#include "Fan.h"
#include "gd32e230x_conf.h"
#include "main.h"


void fans_init(void)
{
	rcu_periph_clock_enable(RCU_GPIOB);  
  gpio_mode_set(GPIOB, GPIO_MODE_OUTPUT, GPIO_PUPD_NONE, GPIO_PIN_6);          
  gpio_output_options_set(GPIOB, GPIO_OTYPE_PP, GPIO_OSPEED_50MHZ, GPIO_PIN_6); 
  gpio_bit_reset(GPIOB, GPIO_PIN_6);   
	
	sts_data_t *data = get_sts();
	data->fans = fans_on_off;
}


void fans_on_off(unsigned char status)
{
	if(status == FANS_OFF)
	{
		gpio_bit_reset(GPIOB, GPIO_PIN_6); 
	}else if(status == FANS_ON)
	{
		gpio_bit_set(GPIOB, GPIO_PIN_6); 
	}else{
	
	}
}