SmartPDCode/control/STS/HARDWARE/Relay/Relay.c

/*********************************************************************************************************
* Module   : Relay.c
* Abstract : Relay module is used to control external relay,of which combine with latch! 
* Version  : 1.0.0
* Author   : Leopul(COPYRIGHT 2025 - 2027 Leopul. All rights reserved.)
* Complete : 2025-02-16
* Content  : None
* Note     : None
*********************************************************************************************************/
#include "Relay.h"
#include "gd32e230x_conf.h"
#include "Sn74lvc573.h"
#include "R_Led.h"
#include "main.h"

#define RELAY_1  GPIO_PIN_3
#define RELAY_2  GPIO_PIN_4


static void ConfigRelayGPIO(void);  

static void ConfigRelayGPIO(void)
{
	rcu_periph_clock_enable(RCU_GPIOB);
	
	gpio_mode_set(GPIOB, GPIO_MODE_OUTPUT, GPIO_PUPD_NONE, RELAY_1);          
  gpio_output_options_set(GPIOB, GPIO_OTYPE_PP, GPIO_OSPEED_50MHZ, RELAY_1); 
  gpio_bit_reset(GPIOB, RELAY_1);  
	
	gpio_mode_set(GPIOB, GPIO_MODE_OUTPUT, GPIO_PUPD_NONE, RELAY_2);          
  gpio_output_options_set(GPIOB, GPIO_OTYPE_PP, GPIO_OSPEED_50MHZ, RELAY_2); 
  gpio_bit_reset(GPIOB, RELAY_2); 
	

}
void InitRelay(void)
{
	Init74Lvc();
  ConfigRelayGPIO();  
	sts_data_t *data = get_sts();
	data->choise_input = choise_input;
	data->open_output = out_open;
	data->close_output = out_close;
}



void choise_input(uint8_t channel)
{
	sts_data_t *data = get_sts();
	switch(channel)
	{
		case 0:
		{
			unlock();
			gpio_bit_reset(GPIOB, RELAY_1);
			lock();
			data->m_data.md_choise.choise_ch = INPUT_CHANNEL_1;
			in_r_led_on_off(channel);
		}
		break;
		case 1:
		{
			unlock();
			gpio_bit_set(GPIOB, RELAY_1);
			lock();
			data->m_data.md_choise.choise_ch = INPUT_CHANNEL_2;
			in_r_led_on_off(channel);
		}
		break;
		default:
			break;
	}
}


void out_open()
{
		unlock();
		gpio_bit_set(GPIOB, RELAY_2);
		lock();
		out_r_led(0);
}

void out_close()
{
		unlock();
		gpio_bit_reset(GPIOB, RELAY_2);
		lock();
		out_r_led(1);
}