SmartPDCode/control/STS/HARDWARE/Led/Led.c

/*********************************************************************************************************
* Module   : Led.c
* Abstract : Led modules,while be flashing which determing of running normally ! 
* Version  : 1.0.0
* Author   : Leopul(COPYRIGHT 2025 - 2027 Leopul. All rights reserved.)
* Complete : 2025-02-16
* Content  : None
* Note     : None
*********************************************************************************************************/


#include "Led.h"
#include "gd32e230x_conf.h"

static void ConfigLEDGPIO(void);  


#define USR_LED GPIO_PIN_14


static void ConfigLEDGPIO(void)
{
  rcu_periph_clock_enable(RCU_GPIOC);  
	
  gpio_mode_set(GPIOC, GPIO_MODE_OUTPUT, GPIO_PUPD_NONE, USR_LED);          
  gpio_output_options_set(GPIOC, GPIO_OTYPE_PP, GPIO_OSPEED_50MHZ, USR_LED); 
  gpio_bit_reset(GPIOC, USR_LED);                                         
}
void InitLED(void)
{
  ConfigLEDGPIO();  
}

void LEDFlicker1(unsigned short cnt)
{
  static unsigned short s_iCnt; 
  
  s_iCnt++;                      
  
  if(s_iCnt >= cnt)              
  { 
    s_iCnt = 0;                
    gpio_bit_write(GPIOC, USR_LED, 1-gpio_output_bit_get(GPIOC, USR_LED));
  }
}

void LEDFlicker2(void)
{
	gpio_bit_toggle(GPIOC, USR_LED);
}