SmartPDCode/truing_control/PDU-Magnetic-Retention-AC/hardware/PowerSave/power_failure_save.c

#include "gd32f30x_libopt.h"
#include "stdint.h"
#include "Main.h"
#include "At24cxx.h"




void power_save_init(void)
{
#if 0
	rcu_periph_clock_enable(RCU_AF);
	rcu_periph_clock_enable(RCU_GPIOB);
	gpio_init(GPIOB,GPIO_MODE_IN_FLOATING,GPIO_OSPEED_50MHZ,GPIO_PIN_8);

	nvic_irq_enable(EXTI5_9_IRQn,0,4);
	gpio_exti_source_select(GPIO_PORT_SOURCE_GPIOB, GPIO_PIN_SOURCE_8);
	exti_init(EXTI_8,EXTI_INTERRUPT,EXTI_TRIG_FALLING);
	exti_interrupt_flag_clear(EXTI_8);	
#endif
}





void EXTI5_9_IRQHandler(void)
{
#if 0
	if(RESET != exti_interrupt_flag_get(EXTI_8))
	{
			uint8_t buff[4*RelaySlaveChaNum] = {0};
			
			for(int i = 0 ; i < RelaySlaveChaNum;i++)
			{
				int temp = i << 2;
				buff[temp + 0] = EE_ACDC_Total_Consum_Read_Reg[i].ACDC_Consumption >> 24;
				buff[temp + 1] = EE_ACDC_Total_Consum_Read_Reg[i].ACDC_Consumption >> 16;
				buff[temp + 2] = EE_ACDC_Total_Consum_Read_Reg[i].ACDC_Consumption >> 8;
				buff[temp + 3] = EE_ACDC_Total_Consum_Read_Reg[i].ACDC_Consumption >> 0;
			}
			AT24CxxWrite(Eepr_AC_Sing_Total_Consumer_addr, buff,4*RelaySlaveChaNum);		
		exti_interrupt_flag_clear(EXTI_8);
	}	
#endif
}